Installation wasn't too fun since the cord is much too short!The sensor needs to be mounted in an unobstructured area for rain, obviously, so it's likely you need to place it on the roof or other high structure.But the cord isn't that long enough enough for a one-story low ceiling mount! I had to add my own wire which was unnecesarily complicated.Manufacturer should've included more cord or at least have left the wires bare with quick twist on plugs at the end.Anyway, seems to work so far.Click Here to see more reviews about: Claber Automatic Rain Sensor for Aquadue Duplo Water Timer #90915
Product Description:
The unit is designed to operate with the Claber #8410 Duplo 2-line water timer only.Avoid unnecessary wastage of water by turning ff sprinklers when raining.The system will shut down when the internal flow reaches a total level of 2 ounces.Programming will resume when the water evaporates.To connect, simply remove the front panel of the Duplo water timer by pressing the 2 side buttons and slide the connector onto the far left prongs.Supplied with a stainless steel wall bracket, install the sensor in a clear area up to 6 feet distant from water timer without any type of vegetation coverage and away from sprinklers.It is important to keep the orange cover in place to keep out leaves and/or impurities that could impair operation.
Buy cheap Claber Automatic Rain Sensor for Aquadue Duplo Water Timer #90915 now
No comments:
Post a Comment